Airaid 450-636 User Manual
Page 2
Instructions Revision
05.22.13
Contact your nearest Airaid dealer for an Airaid
Intake System for your car, truck or SUV.
The sound of power...The “whistle” means its working!
5. Remove the factory breather hose and spring clamps, and
replace them with the supplied Breather hose and Speed clamps.
Re-torque the throttlebody bolts in a X pattern, to Factory specs.
6. Reinstall the intake tube, tighten the two hose clamps, and
reconnect the breather line or lines.
Re-connect the negative battery cable!
Gasket
Spacer
3. Remove the four bolts that secure the throttlebody to the in-
take manifold and set aside. They will not be reused.
4. Position the Poweraid Spacer between the throttlebody and
the intake manifold with the supplied gasket next to the throttle-
body as shown. Make sure the “flow” arrow that is printed on
the spacer is pointing towards the intake manifold. Insert the
provided bolts and washers through the throttlebody, gasket,
and Poweraid Spacer.
Speed Clamps