Airaid 450-610 - Manual (Page 2)

5. Reinstall the intake tube, and tighten the hose
clamps.
Reconnect the breather hose to the intake tube.
7. Re-connect the negative battery cable!
Instructions Revision
07/15/08
Contact your nearest Airaid dealer for an Airaid Intake
System for your car, truck or SUV.
The sound of power...The “whistle” means its working!
3. Using the two nuts removed in step #2, install them
as shown, on one of the studs, snug them together, and
then turn the nut closest to the manifold, and remove
the stud. Repeat the procedure on the second stud. 4. Install two bolts (#2), and washers (#3) thru the
throttle body, thru the gasket (#4), thru the Poweraid
Spacer (#1), and into the intake manifold as shown.
Use caution to retain the factory o-ring gasket on
the plastic intake manifold.
Next install the remaining bolts in the bottom holes of
the throttle body, and tighten evenly to the manufac-
ture's specifications. Do Not Over Tighten The Bolts!
Bolts &
Washers
Gasket
Spacer
6. Inspect & test the throttle linkage for full open
and closed travel before driving. Some cruise and
kickdown cables may require adjustment. Please
refer to vehicles service manual for proper adjust-
ment.