Airaid 450-610 User Manual
Parts list

1. Disconnect the negative battery cable!
Using a 5/16” socket, loosen two hose clamps that
hold the intake tube between the throttle body, and the
air cleaner lid.
Turn the green tab, and disconnect the breather hose
from the air intake tube. Remove the tube from the
vehicle.
2. Remove beauty cover on top of intake manifold if
equipped. (2008-09)
A). Using a 5/16” deep socket, remove two studs from
the top of the throttle body.
B). Using a 10mm socket, remove two nuts from the
studs on the bottom of the throttle body.
Flip the throttle body out of the way.
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the in-
struction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
Parts List
#1 Poweraid Spacer
x1
#2 6mmx50mm Bolts
x4
#3 6mm Flat Washers
x4
#4 Fiber Gasket
x1
Tools Required For Installation
5/16” Deep , 10mm, Sockets
Ratchet and Extension
10mm Wrench
Installation Instructions
Part Number 450-610
Poweraid Spacer For
2005-09 Ford Mustang GT
4.6L V-8
A.
B.
Included with your Poweraid Spacer is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.