Airaid 400-614 User Manual
Page 2
5. Reinstall the factory intake tube onto the throttle
body, and then onto the factory air cleaner cover.
Tighten the two hose clamps, and reconnect the
breather hose.
Instructions Revision
01/03/07
Contact your nearest Airaid dealer for an Airaid Intake
System for your car, truck or SUV.
The sound of power...The “whistle” means its working!
3. Install the supplied gasket between the throttle
body, and the Poweraid Spacer. Use caution to re-
tain the factory o-ring in the groove on the intake
manifold. Slide two of the supplied 6mm bolts and
washers thru the top holes of the throttle body and
into the manifold.
4. Next install the remaining two bolts and washers
thru the throttle body and into the manifold. Tighten
all four bolts evenly to the manufacture’s torque
specifications.
Gasket
Poweraid Spacer
Throttle Body
6. Inspect & test the throttle linkage for full open
and closed travel before driving. Some cruise and
kickdown cables may require adjustment. Please
refer to vehicles service manual for proper adjust-
ment.
7. Re-connect the negative battery cable!