Airaid 400-588 - Manual (Page 2)

2
Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner assembly.
3. Remove (2) 8mm bolts from the throttle linkage bracket. (Ref. D)
4. Remove (4) bolts from the throttle body. (Ref. C)
5. Install the power plate using both gaskets. (Ref. A)
A. Place one gasket between the throttle body and power plate.
B. Place second gasket between the power plate and intake manifold.
6. Install (4) 8mm x 50mm bolts and (4) 8mm lock washers. Refer to Step 4
7. Replace vent tube rubber hose using furnished 2 3/4” long rubber hose.
8. Install (2) linkage plates using (2) 8mm flat head screws. (Ref. D)
9. Install linkage bracket using (2) spacers and (2) 5/16-18” x 3/4” bolts. (Ref. D)
10. Inspect & Test throttle linkage for full Open & Closed travel before driving. Some cruise or kickdown cables
may require adjustment. Please refer to your vehicles service manual for proper adjustment.
11. Reinstall air cleaner assembly using Step 2 as an example.
12. Reconnect battery cable. Enjoy!
The sound of power...The “whistle” means its working!
Rv. 05/04
Ref. D- (2) Linkage Plates
(2) Spacers 5/16” thick with 5/16” hole
(2) 8mm x 16mm flat head screws
(2) 5/16-18” x 3/4” bolts
Ref. A– (1) Power Plate
(2)
Gaskets
Ref. C- (4) 8mm x 50mm Bolts
(4)
8mm Lock Washers
Ref. B– Throttle Body
AIRAID Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com