AEC OFE Blender - Manual (Page 31)

Page 30 OFE Series Weight Loss Feeders
6-3 Controller Setup
This section describes the proper setup of the OFE Feeder control parameters. These
parameters are operator changeable; however, these items should only require setup
during the initial installation. Only authorized personnel should change them. For
security reasons, the menu that is used to access these parameters is password
protected.
Many of the variables and setup parameters have been preset at the factory and do not
need to be changed. However, this section of the manual will address all of the setup
parameters that were available at the time of printing. The purpose of this is to
familiarize the reader with all the setup parameters and their usage.
6-4 Mechanical
The mechanical design of the feeder is very simple and very little maintenance is
required. The only moving parts are the reload hopper dump valve. The following
maintenance is suggested:
Daily
• Inspect feeder for any loose parts-tighten them immediately.
Monthy
• Inspect air regulator and air safety circuits, if equipped.
• Recalibrate feeder only if necessary.