beautypg.com

6 maintenance, 1 work rules, 2 maintaining feeders – AEC OFE Blender User Manual

Page 30

background image

OFE Series Weight Loss Feeders

Page 29

6 Maintenance

6-1 Work Rules

The installation, operation, and maintenance of this equipment must follow all
applicable work and safety codes for the location where it is used. This may include,
but is not limited to, OSHA, CSA, NEC, SPI, and other local, national, and
international regulations. In addition, you must observe the following specific rules:

; Read and follow these instructions when installing, operating, and maintaining

your equipment. If the instructions become damaged or unreadable, you can
obtain additional copies from the Service Department at AEC, Inc.

; Only qualified people may work on or with this equipment.
; Work only with approved tools and devices.
; Turn off and lock out the power switch when maintaining or servicing your

blender system.

; Disconnect and lock out main power before servicing electrical equipment.

6-2 Maintaining

Feeders

AEC feeders need periodic maintenance to provide long dependable service. Check
these elements regularly:

• Maintain proper air pressure and drain water from trap assembly on regulator – as

required.

• Periodically lubricate slide gate rails.

WARNING!

Always remove plug and disconnect power before servicing
blender.


Always read operating manual before operating or servicing
blender.