AEC OFE Blender - Manual (Page 13)

Page 12 OFE Series Weight Loss Feeders
2 Safety
2-1 Work Rules
Install, operate, and maintain this equipment according to applicable work and safety
codes for your location. This includes OSHA, CE, NEC, CSA, SPI, and many other
local, national, and international regulations. Obey these specific work rules:
Read and follow the instructions in this manual before
installing, operating, or maintaining any equipment.
Additional copies are available from AEC, Inc.
Only qualified persons should work on, or with, this
equipment.
Work only with approved tools and devices.
Disconnect and lock out power while working on this
equipment.
2-2 Tools and Equipment Needed
You’ll need the following:
• Hand tools
• Fork lift or overhead lift
• Wire, conduit, and fittings for wiring runs (if receptacle is not
already in place)
• Mounting bolts with nuts and washers
2-3 Mechanical Installation
OFE Series Feeders may be mounted on the machine, a stand, or a
mezzanine. Be sure it is securely attached and additional bracing
is used if necessary. The sections on the following pages explain
general installation rules.
Read manual thoroughly before installing the
OFE feeder.
Use approved safety straps or chains to lift the
feeder at the marked lifting points.