How to connect audio in device – ACTi E924~E929 User Manual
Page 29
Hardware Manual
How to Connect Audio In Device
The camera comes with an audio jack where an audio input device, such as a microphone with a
built-in amplifier, can be connected. The audio-in jack is covered by a rubber protection.
WARNING:
Do not remove this rubber protection if the audio-in jack will not be used to avoid
water or dust from entering the jack.
To connect an audio input device, do the following:
1.
Pull to remove the rubber protection.
2.
Connect the audio input device.
NOTE:
The microphone must have a built-in amplifier. Connecting an ordinary microphone
will dwarf sounds and will result in inaudible recording.
3.
If the camera is installed outdoors, be sure to wrap the audio connectors with
Waterproof
Tape
(can be purchased in hardware stores).
DISCLAIMER:
ACTi will not be responsible for camera damage due by water leakage
caused by improper waterproofing of cables.
Audio Input Jack
Audio Device
- E924M~E929M E918 E918M E919 E919M E920 E920M E921 E921M E922 E922M E923 E923M Outdoor Mini Dome and Mini Fisheye Dome on Hard Ceiling Outdoor Mini Dome and Outdoor Mini Fisheye Dome on Dropped Ceiling Outdoor Mini Dome and Mini Fisheye Dome on Straight Wall Outdoor Mini Dome and Mini Fisheye Dome on Tilted Wall 2MP Outdoor Mini Dome Camera with 2.55mm Fixed Lens and RJ-45 Connector