Westermo TD-34 User Manual
Page 34

34
6610-2203
W – Connect Message Control
This command controls the format of CONNECT messages.The parameter value, if valid, is
written to S31 bits 2 and 3.
W0 Upon connection, the modem reports only the DTE speed (e.g., CONNECT 19 200).
Subsequent responses are disabled. (Default)
W1 Upon connection, the modem reports the line speed, the error correction protocol,
and the DTE speed, respectively. Subsequent responses are disabled.
W2 Upon connection, the modem reports the DCE speed (e.g., CONNECT 14 400).
Subsequent responses are disabled.
&W – Store system settings
Saves the current (active) configuration (profile), including S-Registers, in one of the two user
profiles in NVRAM as denoted by the parameter value.This command will yield an ERROR
message if the NVRAM is not operational as detected by the NVRAM test.
The current configuration is comprised of a list of storable parameters illustrated in the
&V command.These settings are restored to the active configuration upon receiving an
Zn command or at power up (see &Yn command).
Syntax:
AT&W
= 0
Store the current configuration as profile 0.
= 1
Store the current configuration as profile 1.
Examples:
Result Codes: OK
ERROR
Otherwise