Westermo TD-34 - Manual (Page 25)

25 6610-2203
&G – Select Guard Tone
The modem generates the guard tone selected by this command according to the parameter
supplied (DPSK modulation modes only).The parameter value, if valid, is written to S23 bits 6
and 7.
&G0 Disables guard tone. (Default).
&G1 Disables guard tone.
&G2 Selects 1 800 Hz guard tone.
This command may not be permitted in some countries.
*G – Password control
This command controls whether or not the modem will handle Password and/or Call back
functionality.Value is written to S14 bit 6.
Syntax: AT*G
= 0 Disables password control (default)
= 1 Enables password control
Examples:
Result Codes: OK
= (0-1)
ERROR Otherwise
H – Hangup
This command initiates a hang up sequence.
Syntax: ATH
= 0 The modem will release the line if the modem is cur-
rently on-line. Country specific, modulation specific,
and error correction protocol specific (S38) processing
is handled outside of the H0 command.
= 1 If on-hook go off-hook for S7 time.
Examples:
Result Codes: OK
= (0-1)
ERROR Otherwise
I – Information
This command causes the modem to report the requested result according to the command
parameter.
Syntax: ATI
= 0-7 Please refer to reference manual
= 8 Switch settings
= 9 Software version numbers (MCU and CS)
Examples: ATI8
000 000 000 000
OK
ATI9
4100-8050
4100-8040
OK
Result Codes: OK = (0-9)
ERROR Otherwise