Westermo TD-34 - Manual (Page 14)

14 6610-2203
5.3 Configuration
TD-34 can be configured via AT-commands on the service interface, or by a remote modem (if
the TD-34 is set for remote configuration, see SW 4).
5.3.1 DIP-switch settings
DIP-switches are accessable under the lid on top/front of the unit. DIP-switches are
used to configure the unit.
Warning!
Prevent damage to internal electronics from electrostatic discharges (ESD) by
discharging your body to a grounding point (e.g. use of wrist strap), before the
lid on top/front of the unit is removed.
Warning! Do not open connected equipment.
Prevent access to hazardous voltages by disconnecting the unit from AC/DC mains
supply and all other electrical connections.
NOTE! The change of DIP-switch settings are valid only after a power on.
If configured by any other method during normal operation, this new
configuration override the DIP-switch settings. However, after a new
power on the DIP-switch settings have precedence.
!
!