Watson-Marlow MC12 - Manual (Page 37)

Operators and Reference Manual
MC12
MC12 OM RM 1.03_EN Version: 1.03 Date: 2010-11-17 Page 37 of 46
7.2 Terminate dispensing
When the filler has completed the number of fillings asked for in F6: it stops automatically. If
is pressed again, the filler completes the programmed number of fillings once more.
If you want to stop the fillings, before the programmed number has been completed, press
, and the filler stops after completing the filling in progress.
The filling series can be completed by pressing .
If you want to stop IMMEDIATELY, also in the middle of a filling, press twice, and the
filler stops immediately.
The filling series can be completed by pressing +, and the interrupted filling are
counted in.
7.3 Continuous run
MC12 can also control a filler as a pump so the pump runs continuously.
The pumping is started by pressing +.
The filler starts with the entered acceleration and runs up to the required number of revolutions
per minute.
The filler runs at this velocity until stopped by pressing .
In Function 11 the current uncalibrated flow can be read.
If an exact flow read-out is required, the system must be calibrated. This calibration shall be
made as indicated in the next paragraph .
It is recommended to use a rather long filling for this calibration of the flow value.