Watson-Marlow MC12 - Manual (Page 29)

Operators and Reference Manual
MC12
MC12 OM RM 1.03_EN Version: 1.03 Date: 2010-11-17 Page 29 of 46
6.7.37. Function 47 - Printer set-up
This function tells the system how to transmit data to a connected printer and which port to use
for the transmission.
Press: <4>+<7>+
Choose the port number.
Here the port number is entered followed by
0 = Disconnecting printer port
1 = RS-232/1
2 = RS-232/2
Now the system asks for the baud rate:
The system will suggest the value already stored. This value can be either approved by
or it can be overwritten by the baud rate required according to the following table:
75
110 134 150 300 600 1200 1800 2000 2400 4800 9600
The system will only accept a value from the above table.
When the baud rate has been entered in the system, the system will prompt the operator to enter
a control word.
The control word, which is an integral number from 1 to 12, will inform the system of the format in
which data is to be transmitted to the printer.
The format is chosen from the following table:
1 = 7 data bits 1 stop bit no parity
2 = 7 data bits 1 stop bit even parity
3 = 7 data bits 1 stop bit odd parity
4 = 7 data bits 2 stop bits no parity
5 = 7 data bits 2 stop bits even parity
6 = 7 data bits 2 stop bits odd parity
7 = 8 data bits 1 stop bit no parity
8 = 8 data bits 1 stop bit even parity
9 = 8 data bits 1 stop bit odd parity
10 = 8 data bits 2 stop bits no parity
11 = 8 data bits 2 stop bits even parity
12 = 8 data bits 2 stop bits odd parity
It is not possible to set the system to transmit at any other rates or formats.
Default set-up for CITIZEN printer model: iDP562-R5L
2400 Baud rate