Watson-Marlow MC12 - Manual (Page 27)

Operators and Reference Manual
MC12
MC12 OM RM 1.03_EN Version: 1.03 Date: 2010-11-17 Page 27 of 46
Calibration and recalibration should not be carried out under drive 0 but under the respective
drive numbers. See the chapter on calibration for further details.
Drive 0 in serial mode
The following parameters are system parameters and should therefore be entered under drive 0:
F 1: Volume F 3: Velocity
F 4: Acceleration/deceleration F 5: Reversing
F 6: Batch size F 7: Delay
F17: Timer 1 F18: Timer 2
F19: Timer 3
Calibration Recalibration
Function 2, tube diameter, is entered under the respective drives by entering F41 and drive
number. In this way the last drive may carry out only a small part of the total fill, providing a small
tube is selected for this drive.
6.7.32. Function 42 - Set date
The MC12 has a built-in electronic clock and calendar. With Function 42 the date can be set in
the following format:
YY/MM/DD
YY = the year from
00 - 99
MM = the month from 01 - 12
DD = the day of the month from 01 - 31
The date is entered by first entering the year, then the month and finally the day.
Example: <4>+<2>++<0>+<8+<0>+<7+ENT>+<2+<2
By pressing the new date will be stored in the system.
The system calculates automatically the days of the month. If the date 07/06/31 is entered by
mistake, the system will correct the date when the clock changes from 23/59/59 to 00/00/00.
The system does NOT take Summer Time (daylight savings time) into account.