Watson-Marlow MC12 - Manual (Page 23)

Operators and Reference Manual
MC12
MC12 OM RM 1.03_EN Version: 1.03 Date: 2010-11-17 Page 23 of 46
If the number is occupied by a program already saved, the system will ask:
“OVERWRITE PGM. (Y/N)”
If is pressed, the old program is deleted and the new program is saved with this number.
If is pressed, the system will go back to the position from which a new program number can
be selected.
Select a new program number and press to confirm this new number.
The old program saved under the number originally suggested will be kept and the program will
be saved under the new number.
If program number 0 is selected, the function is left without saving the program.
6.7.26. Function 32 - Load program
This function loads a program already saved and overwrites the current parameters with the
values of the program.
When pressing <3>+<2>+ the system will ask: “LOAD PROGRAM NO.:”
By pressing the required program number followed by , the operating parameters saved
under the specified program number will be entered as the current parameters under the
respective functions.
At the same time, the following functions will be reset: F8 - F9 - F11 - F20 - F21.
If a calibration of the specific tube has been carried out, these parameters will also be loaded.
If program number 0 is selected, the function is left without loading a program and the system will
keep the current values.
6.7.27. Function 33 - Delete program
This function deletes the required program.
If a complete program is to be deleted, this can be done by overwriting it via Function 31, or the
program can be deleted via Function 33.
When entering <3>+<3>+ the system will ask for the program number to be deleted.
When pressing the required program number followed by the specified program will be
deleted.
If a number is entered under which no program is saved, the system will not accept it and the
number must be corrected, or the function can be left by pressing <0>+.