HP Spectre x2 - Manual (Page 53)

6. Flex the left side of the back cover until the audio jack (1) and USB port clear the openings in
the back cover.
7. Lift the left side of the system board (2) until it rests at an angle.
8. Remove the system board (3) by sliding it up and to the left at an angle.
Reverse this procedure to install the system board.
Heat sink
Description Spare part number
Heat sink (includes replacement thermal material) 830313-001
Before removing the heat sink, follow these steps:
1. Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2. Disconnect the power from the slate by unplugging the power cord from the slate.
3. Disconnect all external devices from the slate.
4. Remove the display panel assembly (see Display panel assembly on page 20 ), and then remove
the following components:
a. Battery (see Battery on page 23 )
b. Solid-state drive (see Solid-state drive on page 24 )
c. WWAN module (see WWAN module on page 25 )
d. Speakers (see Speakers on page 29 )
Component replacement procedures 43