HP Spectre x2 - Manual (Page 30)

5 Removal and replacement procedures
CAUTION: Components described in this chapter should only be accessed by an authorized service provider.
Accessing these parts can damage the slate or void the warranty.
Component replacement procedures
NOTE: Details about the slate, including model, serial number, product key, and length of warranty, are on
the service tag on the back of the slate. See Service tag on page 10 for details.
This chapter provides removal and replacement procedures.
There are as many as 40 screws that must be removed, replaced, and/or loosened when servicing the slate.
Make special note of each screw size and location during removal and replacement.
Display panel assembly
Description Spare part number
Display panel assembly, 12.0-in, BrightView (1920×1080), WLED, WUXGA+, UWVA (eDP 1.3), ultraslim
(2.4-mm), TouchScreen display (includes 2 TouchScreen cables) 830345-001
Before disassembling the slate, follow these steps:
1. Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2. Disconnect the power from the slate by unplugging the power cord from the slate.
3. Disconnect all external devices from the slate.
Remove the display panel assembly:
CAUTION: Before resting the slate on any of its sides, make sure it is adequately supported. Failure to
follow this caution can result in damage to the slate display panel assembly and other slate components.
1. Rest the slate on its top edge, with the POGO pin docking connector facing up.
2. Detach the POGO pin bezel (1) from the display panel assembly. (The POGO pin bezel is attached to
the display panel assembly with double-sided adhesive.)
The POGO pin bezel is available using spare part number 830346-001.
20 Chapter 5 Removal and replacement procedures