HP Spectre x2 - Manual (Page 46)

3. Remove the WLAN antenna cables and transceivers (3).
Reverse this procedure to install the WLAN antenna.
WWAN antenna
Description Spare part number
WWAN antenna, ME936(includes cables, transceivers, and double-sided adhesive) 830331-001
WWAN antenna, ME206 (includes cables, transceivers, and double-sided adhesive) 834558-001
Before removing the WWAN antenna, follow these steps:
1. Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2. Disconnect the power from the slate by unplugging the power cord from the slate.
3. Disconnect all external devices from the slate.
4. Remove the display panel assembly (see Display panel assembly on page 20 ), and then remove
the following components:
a. Right microphone (see Microphone on page 31 )
b. Front-facing webcam (see Front-facing webcam on page 32 )
c. Rear-facing webcam (see Rear-facing webcam on page 33 )
Remove the WWAN antenna:
1. Disconnect the WWAN antenna cables (1) from the terminals on the WWAN module.
36 Chapter 5 Removal and replacement procedures