HP Spectre x2 - Manual (Page 34)

2. Remove the battery (2).
Reverse this procedure to install the battery.
Solid-state drive
Description Spare part number
512-MB, M2.2280, SATA-3, solid-state drive supporting TLC 763008-006
256-MB, M2.2280, SATA-3, solid-state drive supporting TLC 760615-014
256-MB, M2.2280, PCIe-2×4, solid-state drive 814693-001
128-MB, M2.2280, SATA-3, solid-state drive supporting TLC 759848-011
128-MB, M2.2280, SATA-3, MH solid-state drive 827560-008
Before removing the solid-state drive, follow these steps:
1. Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2. Disconnect the power from the slate by unplugging the power cord from the slate.
3. Disconnect all external devices from the slate.
4. Remove the display panel assembly (see Display panel assembly on page 20 ).
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.5 screw (1) that secures the solid-state drive to the slate. (The solid-state
drive tilts up.)
24 Chapter 5 Removal and replacement procedures