HP Spectre x2 - Manual (Page 41)

Microphone
Description Spare part number
Microphone Kit (includes cables, left and right microphones, rubber isolators, and double-sided
adhesive) 830344-001
Before removing the card reader board, follow these steps:
1. Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2. Disconnect the power from the slate by unplugging the power cord from the slate.
3. Disconnect all external devices from the slate.
4. Remove the display panel assembly (see Display panel assembly on page 20 ).
Remove the microphones:
1. Release the ZIF connectors (1) to which the microphone cables are attached, and then disconnect
the microphone cables from the system board.
2. Detach the microphones (2) from the back cover. (The microphones are attached to the back cover with
double-sided adhesive.)
3. Remove the microphones and cables.
Reverse this procedure to install the microphones.
Component replacement procedures 31