Vinpower Digital Titan Lightscribe Autoloader - Manual (Page 41)

39
Max Failure per Job
[030] OK?
Setup
13.Max Failure per Job
Setup
14.Max Failure per Drive
Max Failure per Job
[030] OK?
Use the Up or Down button to select the Max Failure per Job
menu and press the ENT/Enter button to enter that menu.
You can select numbers between 1 to 999 by pressing the Up or Down button:
To specify the number of maximum failures per job, you need to
enter/input a three-digit number.
If you need to specify a number that is less than three digits, fill the
leading spaces with zeros (any leading zeros will be skipped). Examples of three-digit numbers are “034”
(thirty four), or “010” (ten).
To enter the number, you need to use the Up or Down button to select the number for each digit and
use the ENT/Enter button or the ESC/Escape button to move the cursor position right or left. Once you've
finished, move the cursor to “OK” and press the ENT/Enter button. For example, if you want to specify a
counter value of 21 (twenty one). The three-digit value would be “021.” To input the desired quantity, do the
following:
Make sure the cursor is located at the first position (First blinking position):
 Press the Down button repeatedly until “0” is displayed.
 Press ENT/Enter button once to move the cursor to the next position.
 Press the Down button repeatedly until “2” is displayed.
 Press ENT/Enter button once to move the cursor to the next position.
 Press the Down button repeatedly until “1” is displayed.
 Now, “021” is displayed, press ENT/Enter button once and the cursor moves to “OK”.
Then, press the ENT/Enter button once to submit your maximum failures per job.
13.14 Max Failure per Drive
Use this setting to set the maximum failures each drive is allowed per job. Once the maximum is reached for
any particular drive, such drive will be disabled for the remainder of the job. The default value for this setting
is 5.
Use the Up or Down button to select the Max Failure per Drive
menu and press the ENT/Enter button to enter that menu.
You can select numbers between 1 to 999 by pressing the Up or Down button:
To specify the number of maximum failures per job, you need to
enter/input a three-digit number.
If you need to specify a number that is less than three digits, fill the
leading spaces with zeros (any leading zeros will be skipped). Examples of three-digit numbers are “034”
(thirty four), or “010” (ten).
To enter the number, you need to use the Up or Down button to select the number for each digit and
use the ENT/Enter button or the ESC/Escape button to move the cursor position right or left. Once you've
finished, move the cursor to “OK” and press the ENT/Enter button. For example, if you want to specify a
counter value of 21 (twenty one). The three-digit value would be “021.” To input the desired quantity, do the
following:
Make sure the cursor is located at the first position (First blinking position):
 Press the Down button repeatedly until “0” is displayed.
 Press ENT/Enter button once to move the cursor to the next position.
 Press the Down button repeatedly until “2” is displayed.
 Press ENT/Enter button once to move the cursor to the next position.