Vinpower Digital Titan Lightscribe Autoloader - Manual (Page 21)

19
Duplicator 3.37
1.Copy (SM)
Duplicator 3.37
8.Master Mode
Master Mode:
Multi Master
Master Mode:
Single Master
Duplicator 3.37
1.Copy (SM)
Chapter 2: Operation
This chapter shows each of the menu options and how they are used.
1. Copy
The Copy menu option or the front panel Copy quick key have two different modes of operation:
 Single Master Mode: This mode requires that a single master disc is loaded onto the hard drive
prior to initiating the duplication process. This mode is ideal if your job involves one or very few
master disc(s).
 Multi Master Mode (Batch Mode): This mode does not require you to manually pre-load your master
onto the HDD. Simply place the master disc(s) on top of the corresponding stack of blank discs
needed for that particular job. This mode is ideal if you have numerous master discs and fewer
copies for each master disc.
These modes are described in detail in “Single Master and Multi Master Modes” on page 16. If you are
making copies in Single Master Mode, continue on to the next section. If you are making copies in Multi
Master Mode, jump ahead to “Making Copies in Multi Master Mode” on page 21.
1.1 Making Copies in Single Master Mode
This process will copy your master disc on to several blank discs simultaneously. This mode requires that
your master disc is loaded into a partition on the Hard Drive. See “Load Partition” on page 31 for instructions
on how to do this.
Turn on your autoloader and wait until it has booted up. It may take several minutes for the autoloader to go
through its self-adaptive test and auto-calibration procedures. You should see the following signifying your
autoloader is ready:
1.1.1 Select Single Master Mode
Make sure the Master Mode is set to Single Master Mode (SM). If it is
already in Single Master Mode (SM), please skip to step 1.1.2 that starts the
copy process. If it is not, use the
Up or Down button to navigate to the
Master Mode screen.
Press the ENT/Enter button to enter the Master Mode Menu and you will
see a screen similar to one of the following:
Use the
Up or Down button to select Single Master Mode. Press the
ENT/Enter button to submit your selection.
Use the
Up or Down button to navigate back to the Copy Menu.