Vinpower Digital Titan Lightscribe Autoloader - Manual (Page 40)

38
Setup
11.Disable Drives
Save Changes?
Drive 1 Port 1.0
[*]Enable [ ]Disable
Drive 1 Port 1.0
[ ]Enable [*]Disable
Setting Saved!
Please Restart
Setup
10.ISRC
ISRC
On
ISRC
Off
Setup
12.Overburn
Overburn
On
Overburn
Off
Use the Up or Down button to select the ISRC menu
and press the ENT/Enter button to enter that menu.
Use the Up or Down button to select whether the
ISRC is ON or OFF, and press the ENT/Enter button to
select that option.
13.11 Disable Drives
This feature allows you to disable certain drives/trays when those drives/trays are producing high failure
rates or not functioning properly.
Use the Up or Down button to select the Disable Drives menu and
press the ENT/Enter button to enter that menu.
Use the Up or Down button to select the desired drive/trays you would
like to enable/disable. Then press ENT/Enter or ESC/Escape button to
move the asterisk in front of “Enable” or “Disable”.
Use the Up or Down button until you see the “Save Changes” screen
and press the ENT/Enter button to save the changes you made.
Once the changes are saved, you shall see the “Please Restart” screen and
restart the system to have the new setting take effect.
13.12 Overburn
Overburn is a burning method to bypass the capacity limitations of the media to burn further out onto the
edge of the media. This can result in slightly higher storage capacity; however, it has also been known to
have compatibility playback issues. Please use it with caution.
Note: This works only for CD and BD media. Due to physical limitations of the DVD media, it is not
possible to record more than the advertised capacity.
Use the Up or Down button to select the Overburn menu and press
the ENT/Enter button to enter that menu.
Use the Up or Down button to select whether the Overburn feature is
ON or OFF, and press the ENT/Enter button to select that option.
13.13 Max Failure per Job
Use this setting to set the maximum failures the autoloader is allowed per job. Once the maximum is
reached, the job will be stopped. The default value for this setting is 30.