Verilink TAC 2130 S/T (880-503296-001) Product Manual - Manual (Page 33)

Configuration
Verilink TAC 2130 User Manual 3-11
49 NCC 2020
NCC 2130
SCC 2020
SCC 2130
TAC 2010
TAC 2130
Network LBO = 15 dB; Attenuates transmit signal by 15db. USE ONLY
IF NO SMART JACK IS PRESENT. Implies that the first active device
(repeater, T3 mux, far CSU) is 0 to 1000 feet away.
50 NCC 2020
SCC 2020
TAC 2010
Selects DSX-1 Equipment cable length of 0-132 ft.
51 NCC 2020
SCC 2020
TAC 2010
Selects DSX-1 Equipment cable length of 133-265 ft.
52 NCC 2020
SCC 2020
TAC 2010
Selects DSX-1 Equipment cable length of 266-398 ft.
53 NCC 2020
SCC 2020
TAC 2010
Selects DSX-1 Equipment cable length of 399-532 ft.
54 NCC 2020
SCC 2020
TAC 2010
Selects DSX-1 Equipment cable length of 533-655 ft.
55 NCC 2020
SCC 2020
TAC 2010
DIU 2140
Sets data bus to NONE (CSU mode) [default].
56 NCC 2020
SCC 2020
TAC 2010
DIU 2140
Sets data bus to A (Mux mode).
57 NCC 2020
SCC 2020
TAC 2010
DIU 2140
Sets data bus to B (Mux mode).
58 NCC 2020
SCC 2020
TAC 2010
DIU 2140
Sets data bus to C (Mux mode).
59 NCC 2020
NCC 2130
SCC 2020
SCC 2130
TAC 2010
TAC 2130
Sends in-band CSU loop-up code to far-end CSU, this should cause the
far end CSU to enter a Line Loopback condition.
Code Applies to Description