Verilink PRISM 3030 (34-00208.L) Product Manual - Manual (Page 45)

SNMP Configuration 35
Unit I P
Address
Accepts IP addresses. Each device connected to the LAN is required to have a
unique IP address identifier.
Subnet Mask Provided to manually override the subnet mask setting which is otherwise
discovered by the SNMP agent.
Router IP Address Accepts the IP address of a default router, if one is present.
Filter IP
Address
These eight fields accept the IP address of the source packet filter. If any of these
fields are set, access is allowed only by the specified IP addresses.
Trap IP
Address
Accepts the IP address of a network device where alarm reporting traps are to be
sent. The unit detects and reports T1 network alarms and provides several options
for reporting them, one of which is SNMP traps. When a network alarm occurs,
the unit sends a trap message to up to six destinations on the customer’s network.
SNMP Set Enables or disables the set command responses. Refer to Appendix C for detailed
information on these responses.
The following five menu items use the format shown in the System Edit screen.
The top line in each screen accepts a string of up to 255 characters that identifies
the appropriate group, person, device function, or unit location. Each character is
entered using the up or down arrow keys until the desired character is displayed.
The right arrow moves the cursor to the next position. Continue this pattern until
the last character has been selected and press Select.
Read Community Accepts a character string identifying the group authorized to perform read
operations. The default setting is public.
Write Community Accepts a character string identifying the group authorized to perform write
operations. The default setting is private.
System Contact Accepts a character string identifying the person responsible for a network device.
The default setting is no system contact.
System Name Accepts a character string identifying the functionality of the network device. The
default setting is no system name.
System Location Accepts a character string identifying the physical location of network device. The
default setting is no system location.
Device Info Displays the Ethernet or Token Ring hardware/software revision level.
public
/ =Letter Select=Done =move
Figure 3-17 System Edit Screen