Verilink DIU 2130 (880-503297-001) Product Manual - Manual (Page 26)

DIU 2130 Configuration
3-2 Verilink
Handshake
Control Leads
Each DIU 2130 data port also supports handshaking operation.
Table 3-2 lists the handshaking signal options available on the DIU
for each data port.
Table 3-2 Handshaking Control Signal Options
Data scrambler Yes or No No
(disabled)
DS0 channel assignments User defined None
CSU shelf and slot number User defined 0,0
Description Options
Default
Setting
Handshake Signals Data Port Handshake Options
V.35 RS-449 EIA 530 Signal
Description
Signal
Direction
Turned On
(Set to YES)
Turned Off
(Set to NO)
RTS RS RTS (CA) Request to
Send
To DIU Forced On Factory Default
(normal mode of
operation) follows
input
CTS CS CTS (CB) Clear to Send From DIU Forced On Factory Default
(follows conditioned
RTS. See Note 1)
DTR TR DTR
(CD)
Data Terminal
Ready
To DIU Forced On Factory Default
(normal mode of
operation) follows
input
DSR DM DSR
(CC)
Data Set
Ready
From DIU Forced On Factory Default
(follows conditioned
DTR.
See Note 2)
RLSD RR DCD
(CF)
Data Carrier
Detect
From DIU Forced On Factory Default
(normal mode of
operation.
See Note 3)
Note 1: If the CSU goes into an LOF or receives a yellow (RAI) alarm, CTS is turned off if this handshaking option is not forced on.
Note 2 If the CSU goes into an LOF or receives a yellow (RAI) alarm, DSR is turned off if this handshaking option is not forced
on.
Note 3 If the CSU goes into an LOF alarm condition, DCD is turned off if this handshaking option is not forced on.