Verilink ConnecT 56K DSU (896-502110-001) Product Manual - Manual (Page 64)

Operation
3-34 ConnecT 56K DSU User Manual
Submenu 4 DTE CMD option
The DTE COMMAND option is used to enable the DTE interface for one
of the three different command modes.
3=CONFIG/1=Local/2=DTE Opt./4=DTE CMD Option
Follow standard operating procedures. When 4=DTE CMD OPTION is
flashing: Press the Enter button resulting in the displaying of the first of
the submenu items.
1=Disabled
2=AT Command Set
Continue with standard operating procedures to select menu options. At
the end of the options the system will briefly display “Command
Accepted” and return to the active menu.
Table 3-21 DTE CMD Commands
1=ASYNC 9 BITS Not
applicable 9 bits including start, stop,
parity
2=ASYNC 10 BITS Not
applicable 10 bits including start, stop,
parity
3=ASYNC 11 BITS Not
applicable 11 bits including start, stop,
parity
Front Panel
AT
Command
Description
1=DISABLED Not
applicable Disables all DTE command
modes
2=AT COMMAND SET Not
applicable Enables AT commands from DTE
3=V.25 SNYC Not
applicable Enables V.25bis (SDLC)
commands
4=V.25 BSC/ASNYC Not
applicable Enables V.25 (BISYNC and
ASYNC)
Front Panel
AT
Command
Description