Verilink ConnecT 56K DSU (896-502110-001) Product Manual - Manual (Page 28)

Installation
2-12 ConnecT 56K DSU User Manual
If verbose responses are disabled (ATV0), the 3 character responses listed
below are the only ones returned:
The syntax and possible responses
Following is a list of V.25 bis commands and their possible responses.
CIC Connect Incoming Call:
This command causes the DSU to go online. There are no parameters
associated with this command. Possible indications include: VALA,
CNX, CFIxx
CNL Local Configuration:
This command is used to pass AT commands to the local modem via the
V.25 bis command processor. This allows the ConnecT 56K DSU to be
configured with AT commands via a synchronous interface. The format
of this command is:
CNL[LOCAL PASSWORD];AT[ONE OR MORE AT COMMANDS]
The local password may or may not be required depending on the present
configuration of the unit. Responses to CNL commands are returned in
the data format currently configured. Possible responses include: VALA
and INVAn.
CNR Remote Configuration:
This command is used to pass AT commands over the network to the
remote DSU via the V.25 bis command processor. This allows a remote
ConnecT 56K DSU to be configured from a synchronous interface. The
format of CNR this command is:
CNR[REMOTE PASSWORD];AT[ONE OR MORE AT COMMANDS]
VAL Valid V.25 command pro-
cessed
INV Invalid command received
CFI Call failed
INC Incoming call
CNX Call connected