Verilink ConnecT 56K DSU (896-502110-001) Product Manual - Manual (Page 52)

Operation
3-22 ConnecT 56K DSU User Manual
Status Displays
Remote With TP
TEST Err - 00
Table 3-8 Test Displays
Table 3-9 Available interface leads
1 = Exit Test and 2 = Display Status
The menu choices here are used to immediately exit the test selection or
to re-enter status display. These menu items are available only after tests
have been performed.
When a test has been requested, the system briefly displays “Please Wait”
before presenting the first test display. At any test result display: Press the
Quick # key to access the 1=EXIT TEST/2=DISPLAY STATUS submenu
or press the Cancel key to change from the status display to the main
menu resulting in the TEST selection being active (flashing).
Local DTE & Loop Type of test being performed
Loop 56K Loop rate
DTE 56K Sync DTE rate and data type
TR Terminal Ready Input
SR Set Ready Output
LLB Local Loopback Input
RLB Remote Loopback Input
OFF/ON State of the respective leads displayed immediately
above.
Unit in Test Operating mode to ConnecT 56K DSU
Loop is Normal Status of network service
1=EXIT TEST Will effectively exit the testing process
returning to the Main Menu for selection.
2=DISPLAY STATUS Re-enters test display for additional
viewing.