Triplett 9007 - Manual (Page 6)

Page 5
2.14 Do not exceed the maximum voltage or current limitations
of the meter (see product specifications). Doing so may
damage the meter and/or injure the user.
2.15 Do not apply voltage or current to the input of the meter
when it is set to any of the Ohms Ω ranges. Doing so may
damage the meter and/or injure the user.
2.16 Do not apply voltage or current to the input of the meter
when it is set to the Diode Test or Continuity Beeper
modes. Doing so may damage the meter and/or injure
the user.
2.17 Do not attempt to measure a voltage source with the test
leads plugged into the meter’s uAmA or 20A jacks. Doing
so may damage the meter and/or injure the user.
2.18 Do not rotate the Function switch with the test leads
connected to the circuitry to be tested. Doing so may
damage the meter or the circuitry, and/or injure the user.
2.19 Replace fuses only with exact or equivalent fuses.
Do not “bridge” fuses out of circuit. Failure to observe
this precaution may result in damage to the meter or
injury to the user.