Triplett 9007 - Manual (Page 24)

7.3 DC Voltage Measurement:
WARNING!
If the magnitude of the voltage to be measured is unknown, always
start by setting the meter to the highest range, and then to lower
ranges, until a satisfactory reading is obtained.
Do not rotate the RANGE switch with the input applied to the meter.
If the input voltage is higher than 1000VDC (CAT I, CAT II, or CAT
III), or 600V DC (CAT IV), do not attempt to measure!
Use Caution when measuring voltages above 50V DC.
7.3.1 Connect the black test lead to the COM jack and the red test
lead to the VOLT / DIODE / OHM / CAP “V Ω CAP” jack.
7.3.2 Set the RANGE switch to a V position. If the magnitude
of the voltage is unknown, set the RANGE switch to the highest
V position. If the input voltage is higher than the
previously stated limits, do not attempt to measure!
7.3.3 Connect the test probes to circuit being measured.
The LCD will display the DC voltage.
Page 23