Tri Tool 648RBL Clamshell Hydraulic 2 Piece User Manual
Page 30
30
TRI TOOL INC.
92-1146 : Rev. 131230
NOTE:
NOTE:
NOTE:
Loosen the Set Screws holding Tool Bits A, D and E.
Push Tool Bit A back flush with the ends of Tool Bits D and E that are in contact with
the cut edges made by Tool Bits B and C.
Tighten the Set Screws holding Tool Bits A, D and E.
Rotate the Feed Sprocket of Tool Block No 2 clockwise so as to move the Tool
Holder away from the pipe cut far enough so that Tool Bits B and C will not cut
during this recovery sequence.
During this recovery sequence, the only Tool Bits that are to be cutting are
Tool Bits D and E so that they may catch up to the bevel made by Tool Bits B
and C.
All other Tool Bits must be pulled back from the cutting surface.
When a blend has been achieved, Tool Bit A must be returned to its original
position so that the desired land may be cut.
Loosen the Set Screws Holding Tool Bits A, D and E.
Push Tool Bit A forward until it makes contact with the bottom of the slot.
Do not move Tool Bits D and E.
Rotate the Feed Sprocket for Tool Block No. 2 counterclockwise to bring Tool Bits B
and C back into contact with the bevel that they have previously cut.
Visually check the Feed Pin to Sprocket engagement for Tool Block No. 2.
Leave Tool Bits D and E in contact with the beveled surface made by Tool Bits B and
C as shown in the previous figure.
Resume the pipe cutting operation.
Go to paragraph, 'When the machining operation is finished, disengage the Feed Pin
by pulling the Tripper Shaft to the 'out' position.'.