Tri Tool 648RBL Clamshell Hydraulic 2 Piece - Manual (Page 10)

10
TRI TOOL INC.
92-1146 : Rev. 131230
NOTE:
MAINTENANCE
All components should be cleaned and coated with a light film of oil prior to use.
Use a clean, non-detergent oil, preferably SAE 10 (90 SSU) or lighter.
The motor warranty is void if damage occurs from a contaminated hydraulic
fluid.
If the Clamshell is operated in such a manner that the Tool Blocks collects debris
while cutting, the Tool Blocks and the Feed Screws should be cleaned after each
cutting operation.
MAINTENANCE SCHEDULE
Daily
Wipe the unit down and spray with rust preventative under severe humidity
conditions.
Visually inspect for loose screws, missing screws, damage, etc.
Clean Up