Tri Tool 648RBL Clamshell Hydraulic 2 Piece - Manual (Page 29)

29
Model 648SB Low Profile Clamshell (2 Piece)
92-1146 : Rev. 131230
Go to paragraph, 'If too deep a cut has been made by Tool Bits B and C...'.
Retract Tool Bits D and E without changing the position of Tool Bit A.
Tighten the Set Screws holding Tool Bits D and E.
Go back to paragraph, 'Turn the Hydraulic motors on to full speed.'
If too deep a cut has been made by Tool Bits B and C, as shown in the
following image, then proceed to paragraph 'Loosen the Set Screws holding
Tool Bits A, D, and E.'.
Tool Bit is to Shallow
Tool Bit is to Deep
Go to paragraph, 'Leave Tool Bits D and E in contact with the Beveled surface made
by Tool Bits B and C as shown in the previous figure.'.