Tri Tool 648RBL Clamshell Hydraulic 2 Piece User Manual

Page 26

TRI TOOL INC.

92-1146 : Rev. 131230

NOTE:

When the Tool Bits sever the pipe, disengage the Feed Pin and let the headstock

rotate two (2) to three (3) times to clear the chip.

Go back to paragraph 'Turn off the Hydraulic Motors by closing the Throttle Control

Valve' and proceed from there.

TOOL BIT ADJUSTMENT FOR PART OFF AND DOUBLE BEVEL

Install Tool Bits A, D and E into the Tool Blocks No. 1 along with two (2) spacers, S3

and S4.

Either Tool Block may be designated as No. 1.

Position the Spacers flush with the inside face of the Tool Holder.

Position Tool Bits D and E approximately 1/2” (12.7 mm) outward from the cutting

edge of Tool Bit A.

Tool Bits D and E will be repositioned to contact the beveled surface as the

cutting progresses.

Tighten the Set Screws holding Tool Bits A, D and E.

Install the Tool Bits B and C into Tool Block No. 2 along with the two (2) spacers S1

and S2.

Tool Bit with Land