Tri Tool 648RBL Clamshell Hydraulic 2 Piece - Manual (Page 17)

17
Model 648SB Low Profile Clamshell (2 Piece)
92-1146 : Rev. 131230
Check that the Tool Holder runs smoothly and evenly for the full length of
travel.
Readjust as necessary.
The Tool holder should move snugly.
In general, when the Slide Rail is set correctly, the Feed Sprocket cannot be
turned by hand but may be turned easily with the spanner wrench.
The torque on the Spanner Wrench should be about 2 ft-lbs (3 Nm) to 5 ft-lbs
(7 Nm).
Tripper Block Assembly Lubrication and Tripper Shaft Adjustment
Remove the Tripper Guard.
Back off the Ball Plunger Set Screw until it disengages from the Tripper Shaft
Assembly.
Remove the Shoulder Bolt and then remove the Tripper Lever.
Remove the Tripper Shaft Assembly from the block and then degrease and
clean all parts.
Apply fresh lubrication to the Tripper Shaft Assembly and to the Shoulder Bolt.
Reassemble in reverse order.
Tool Module Adjustment