Tri Tool 648RBL Clamshell Hydraulic 2 Piece - Manual (Page 25)

25
Model 648SB Low Profile Clamshell (2 Piece)
92-1146 : Rev. 131230
NOTE:
Tool Bit Sever Position
Install the Tool Bits into the Tool Holders.
Reference the 'Tool Bits' section of this manual for installation drawings for
each of the Tool Bits.
The wall thickness plus 3/4” (19 mm) of Tool Bit should be protruding from the end of
the Tool Holder.
Tighten the Tool Bit set screws, then verify there is adequate clearance between the
Tool Bits and the pipe by rotating the Headstock.
The Leading Tool Bit should contact the pipe approximately .020” (.5 mm) to .040
(1.0 mm) before the Trailing Tool Bit.
SEVERING
Tool Bit Sever and Double Bevel Position