Tri Tool 648RBL Clamshell Hydraulic 2 Piece User Manual
Page 23
23
Model 648SB Low Profile Clamshell (2 Piece)
92-1146 : Rev. 131230
Loosen the Clamping Pads and Jackscrews.
Remove the Clamshell from the pipe.
When the Clamshell must be split to remove it, refer to 'Installation of the
Clamshell on an In-Line Pipe' located at the beginning of this section.
You should have a complete pipe sever at this time.
FEED PIN TO SPROCKET ENGAGEMENT
Rotate the Headstock until the Sprocket on the Tool Block begins to approach the
Feed Pin.
The Feed Pin must not strike the Sprocket Tooth straight on.
This action would damage or break the Feed Pin and/or the Sprocket.
The Feed Pin must strike the Sprocket on the edge of the Tooth.
The correct Feed Pin to Sprocket engagement is shown in the following two
images.
Correct Alignment of the Feed Pin
Feed Pin Positioning
- 204B Cutting Head (9 pages)
- 204B Cutting Head (10 pages)
- 204B Cutting Head (9 pages)
- 212B Single Point Spring Hanger Assembly (8 pages)
- 204B Cutting Head (13 pages)
- 204B Cutting Head (36 pages)
- 204B Cutting Head (17 pages)
- 201BA Beveler (36 pages)
- 204B Elbow Mandrel (16 pages)
- 204B Beveler (45 pages)
- 204B Flange Facer (21 pages)
- 206B Elbow Mandrel (17 pages)
- 206B Flange Facer (22 pages)
- 206B Beveler (45 pages)
- 212B ID Tracking Module (17 pages)
- 206B Miter Mandrel (16 pages)
- 206B Sleeve Mandrel (13 pages)
- 208B Elbow Mandrel (20 pages)
- 208B ID Tracking Module (18 pages)
- 208B Miter Mandrel (20 pages)
- 208B Flange Facer (28 pages)
- 208B Sleeve Mandrel (15 pages)
- 212B Elbow Mandrel (16 pages)
- 214B Beveler Single Point Flange Facer (41 pages)
- 212B Flange Facer (22 pages)
- 212B Miter Mandrel (20 pages)
- 212B Single Point Hydraulic Motor Assembly (9 pages)
- 212B Single Point Flange Facer Miter Mandrel (28 pages)
- 212B Sleeve Mandrel (12 pages)
- 214B Elbow Mandrel (20 pages)
- 214B Flange Facer (23 pages)
- 214B ID Track Module (19 pages)
- 214B Miter Mandrel Head Kit (22 pages)
- 214B Sleeve Mandrel (13 pages)
- 236B ID Tracking Module (23 pages)
- 224B Miter Mandrel (27 pages)
- 224B Single Point (30 pages)
- 230B Beveler Flange Facer (16 pages)
- 230B ID Tracking Module (15 pages)
- 230B Lifting Frame (19 pages)
- 236B Miter Mandrel (25 pages)
- 301SP Tube Squaring (35 pages)
- 236B Single Point (32 pages)
- 302 Tube Squaring Micro Feed Assembly (11 pages)
- 302 Tube Squaring (31 pages)