Tech Source Raptor Drivers for Linux - Manual (Page 32)

Raptor Drivers for Linux Installation and Reference Manual
4-10
If multiple Raptor cards are installed, additional
Screen
sections should be created. Other fields should remain
unchanged. For more information please refer to Section 5.5.
4.6.4 ServerLayout Section
This is the section which specifies the server layout for either
single-screen or multi-screen configuration.
This section is not modified automatically by the installation. It
must be modified for your specific configuration.
The following example shows the
ServerLayout
Section for a
single-screen configuration on the Raptor device.
Section "ServerLayout"
Identifier "XFree86 Configured"
Screen 0 "Raptor2100T" 0 0
InputDevice "Mouse0" "CorePointer"
InputDevice "Keyboard0" "CoreKeyboard"
EndSection
Assuming
Screen0
is the console card, the following example
shows the
ServerLayout
section with the Raptor card as the
second screen.
Section "ServerLayout"
Identifier "XFree86 Configured"
Screen 0 "Screen0" LeftOf "Raptor2100T"
Screen 1 "Raptor2100T" RightOf "Screen0"
InputDevice "Mouse0" "CorePointer"
InputDevice "Keyboard0" "CoreKeyboard"
EndSection
NOTE: The ServerLayout section should already exist in
your
XF86Config
file. It must be modified manually to
include the Raptor card.