Tech Source Raptor Drivers for Linux - Manual (Page 23)

4-1
Chapter 4
SOFTWARE INSTALLATION FOR
T-CLASS CARDS
4.1 Overview
This installation chapter describes how to install and configure
the drivers for T-Class Raptor cards. This class of cards
includes the following:
• Raptor 2100T
• Raptor 2500T
• Raptor 1100T
• Raptor 3840T
The installation of I-Class Raptor cards is covered in Chapter 3.
4.2 Requirements
The following are prerequisites for installing the Raptor Drivers
for Linux Software:
• At least 2MB of disk space available in
“/“
and
“/usr“
for
drivers.
• A Raptor card is presently installed in the workstation/server
(See Chapter 2 for instructions on installing a Raptor
graphics card).
• Linux Kernel v2.2.x or v2.4.x installed
• XFree86 (v4.0 or later) installed and configured for the
current console graphics card
• RPM (v3.0 or later) packaging tools
The device driver and DDX module for Linux and XFree86 are
loadable. No kernel changes or X server rebuilds are required.