Tech Source Raptor 4000 (for Solaris) - Manual (Page 29)

25
1.
Connect your cable to the appropriate connector on your
monitor and Raptor 4000/4000e card.
2.
At the prompt type:
ok show-displays
This command will list the installed graphics devices and a
prompt to enter a selection.
3.
Type the letter that corresponds to the Raptor card that you
want to use as the console device. Raptor cards can be
identified by looking for the string TSI in the list of device
names.
For example:
/pci@1e,600000/pci@0/pci@3/pci@0/TSI,rapafp@0
4. At
the ok prompt, type :
ok nvalias
This command will set the specified variable to the path of
the Raptor card. When you type , the string of
the display that was selected in step 3 will be inserted in the
command line.
5. The next step is to set the specified variable to the output-
device. The command to do so is as follows:
At the ok prompt, type :
ok setenv output-device
6. Save your settings and reset the system by typing:
At the ok prompt, type :
ok reset-all
7. Once the system is reset, all console messages will be
directed to the Raptor card.