Tech Source Raptor 4000 (for Solaris) User Manual
Page 10
Raptor 4000/4000e Drivers (Solaris)
6
NOTE: Installation of Raptor4000/4000e driver software is
discussed in Section 3.3
NOTE: If the system is currently using a secondary TSI graphics
device, read section 3.5 on configuring one of the cards as the
console. The console device is the screen on which the boot up
messages will appear. The monitor must be connected to the
console device before you proceed to one of the following software
installation chapters.
The Raptor card is now installed and the system is ready for
software installation. Refer to Chapter 3 for instructions on
installing the software.
This manual is related to the following products: