Tech Source Raptor 4000 (for Solaris) - Manual (Page 12)

Raptor 4000/4000e Drivers (Solaris)
8
3.2 Requirements
The following are prerequisites for installing the Raptor
4000/4000e drivers for Solaris:
• The system is running Solaris 9 or higher.
• At least 2MB of disk space is available in /usr and /.
• One or more of the cards listed in Section 4.1 are presently
installed in the system.
3.3 Installing Raptor 4000/4000e Card
Driver Software
The following are step-by-step instructions for installing the “Raptor
4000/4000e Drivers (Solaris)” software from a CD-ROM.
1.
Install a Raptor card in the computer as described in
Chapter 2.
2.
Boot the computer with the -r (reconfiguration) option by
performing the following steps:
• Power ON the computer.
• Wait until you see boot messages displaying on
the screen, then press and hold the Stop (L1)
key, and then press the A key.
• At the ok prompt, type boot –r.
3. After the system comes up, log in as root.
4. Insert the CD-ROM labeled “Raptor 4000/4000e Drivers
(Solaris)” into the drive.
5. If
/cdrom/cdrom0 exists, the CD-ROM was
automatically mounted. Change directories to the CD-
ROM by typing the following: