5 simulation – Tecfluid CU Series User Manual
Page 40
40
It is an intuitive tool to verify that the instrument has been installed and programmed
correctly.
By means of the "Record" button, you can store data in different computer files, which can
then be processed by other software.
11.5 Simulation
If the converter CU100 is not available, the software can be used in simulation mode.
To do this, press the button "Enter" in the simulation section on the initial screen (see figure
on page 36).
Tabs "Installation" and "Programming" will open.
You will be able to calculate the distance between the transducers and change the data,
although they may not be sent to the converter.
11
ASSOCIATED SOFTWARE WINSMETER CU