Tecfluid CU Series - Manual (Page 36)

36
If you have Internet access, answer “Yes, this time only”.
If you do not have Internet access, answer “No, not this time”.
If you answered “yes”, drivers will be installed automatically. Otherwise, finish the wizard
and then run the file "Drivers_Winsmeter_Setup.exe". The will guide you until the drivers
are installed.
Windows 7
If you have Internet access, a message reporting that the drivers have been installed will
appear.
If you do not have Internet access, a message reporting that the drivers can not be
installed will appear. In this case, run the file "Drivers_Winsmeter_Setup.exe". The
program will guide you through the installation process until the drivers are installed.
Once the computer has the drivers installed, run the WinsmeterCU.exe. The following
screen appears.
To open the lid, remove the four screws. The USB connector is located on the opposite side
of the cable entry glands.
Connect the USB cable at one end to the converter and at the other to the computer where
the software is installed.
Turn on the electronic converter.
Windows XP:
“Found New Hardware Wizard” appears, with the following question:
Can Windows connect to Windows Update to search for software?
11
ASSOCIATED SOFTWARE WINSMETER CU