Tecfluid CU Series User Manual
Page 23
23
After placing the transducer, move the fastening "U" to it until the knurled screw matches
the transducer top notch.
If the alignment guide is not available, place the strap around the pipe and tighten it so
that it holds the transducer.
Once in this position, tighten the screw until the transducer is pressed against the pipe.
5
TRANSDUCERS INSTALLATION
Place the transducer cables by screwing the connectors, and taking into account that the
cable TR1 must be connected to transducer TR1 and the cable TR2 to the transducer
TR2.