Teac US-200 - Manual (Page 8)

8
TASCAM US-200
2 − Names and Functions of Parts
Front panel
1 +48V indicator
This lights when the PHANTOM (+48V)
switch is set to ON.
CAUTION
Do not connect or disconnect microphones
when this indicator is lit.
2
USB indicator
This lights when the USB connection is
active.
3
OL and SIG indicators
OL (overload) indicators
These light just before the input signal
distorts (when it exceeds −2 dBFS).
SIG (signal) indicators
These light when a signal (of −30
dBFS or more) is input through the
corresponding channel.
4
indicator
This lights when the INST/LINE switch is
set to INST.
5
MIC/LINE/INST IN 1 (balanced/
unbalanced) connector
Use this connector for balanced analog
XLR microphone input or as a standard
TRS jack. Use the INST/LINE switch on
the rear panel to set the function of this
standard TRS jack to either balanced line
input (LINE) or unbalanced guitar input
(INST).
• XLR (1: GND, 2: HOT, 3: COLD)
• TRS (Tip: HOT, Ring: COLD, Sleeve: GND)
6
MIC/LINE IN 2 (balanced) connector
Use this connector for balanced analog
XLR microphone input or as a standard
TRS jack for balanced analog input.
XLR (1: GND, 2: HOT, 3: COLD) •
TRS (Tip: HOT, Ring: COLD, Sleeve: GND
•
7
PHONES jack
Use this standard jack to connect stereo
headphones. Use an adapter to connect
headphones with a miniplug.
CAUTION
Before connecting headphones, turn the
LEVEL knob to minimize the volume. Failure
to do so might cause sudden loud noises,
which could harm your hearing or result in
other trouble.
NOTE
The LEVEL knob also adjusts the line output
level.