Teac US-200 - Manual (Page 13)

TASCAM US-200
13
Installing the driver and control
panel for Windows
NOTE
During driver installation, a warning that •
“this software ... has not passed Windows
Logo testing“ will appear.
This message appears when installing a
driver that has not received Windows Logo
testing.
This message appears because the drivers
for TASCAM products have not undergone
Windows Logo testing. We have, however,
confirmed their proper operation.
When this message appears, click
Continue anyway or Install to continue the
installation.
During installation, you must connect the
•
unit in step 7. You should complete the
installation step in less than one minute.
Installation may fail if you take too much
time.
Installation on a Windows computer
1 Confirm that the unit and the PC are not
connected by a USB cable.
2 Insert the included driver installation
CD-ROM into the PC where you will
install it.
3 Click the Install Driver button when the
screen below appears. (If this sreen
does not appear automatically, find and
open the Autorun2.exe program in the
Autorun folder on the driver CD-ROM.)
4 When the language selection screen
(below) appears, select the language
you prefer and then click the OK button.
5 Click the Install the driver button when
the screen below appears.
6 Read the contents of the License
Agreement, and select I accept the
agreement if you agree to the terms.
Next, click the Install button to start
installation.
7 When the screen below appears, use
the supplied USB cable to connect the
unit to the PC.
3 − Installation