Teac US-200 - Manual (Page 5)

TASCAM US-200
5
1 – Introduction
Thank you for your purchase of the TASCAM
US-200 USB 2.0 Audio/MIDI Interface.
Before connecting and using the unit, please
take time to read this manual thoroughly
to ensure you understand how to properly
set up and connect the unit, as well as the
operation of its many useful and convenient
functions. After you have finished reading
this manual, please keep it in a safe place for
future reference.
You can also download the Owner’s Manual
from the TASCAM web site (http://tascam.
com/).
Please also check the above site for the latest
manual updates.
If any data is lost from another MIDI device,
hard disk, MO disc or other media in the same
system where this unit is used, TASCAM will
bear no responsibility for its recovery, nor will
it provide any compensation for such loss.
Main features
USB 2.0 audio/MIDI interface
•
24-bit/96 kHz audio interface •
2-channel analog input signals (L, R) can be •
input at the same time
Two XLR mic inputs (balanced) with high
•
performance microphone preamps
Two standard input jacks (combined with
•
the XLR connectors)
One of the 1/4” phone inputs can be
•
switched to allow direct input (high
impedance) of an electric guitar or electric
bass.
2 unbalanced stereo line outputs (RCA
•
jacks) and a headphone output
Output level from the unbalanced stereo
•
line output and headphones jacks can be
adjusted using a volume knob (same knob
controls both simultaneously)
MIDI IN/OUT
•
Direct Monitor function allows zero-latency •
monitoring of the input
Inputs 1 and 2 can be set to be monitored •
as either a stereo pair or as two mono
channels
Input and overload LED indicators included
•
for each input channel
MON MIX knob allows the balance between
•
the input signals and the output from the
computer to be adjusted for monitoring
Power can be supplied from a USB bus,
•
which is convenient for mobile use
Dedicated Windows (Windows XP, Windows
•
Vista, Windows 7) and Macintosh (OS 10.5,
OS10.6) drivers included
USB 2.0 High Speed (480 MHz) compatible
•
Can supply 48 V phantom power to 2 mic
•
inputs
Cubase LE 5 bundle
•
A note about computer operation
If you are unsure about how to perform
basic computer operations appearing in this
manual, please refer to the owner’s manual
that came with your computer.
To use this unit, you must use the included
CD-ROM to install the dedicated driver on
your computer. For details about installation,
see “Installing the driver and control panel” in
“3 – Installation”.